alright cool cause i didnt want to go buy some without knowing, any cutting blades that you can suggest that wont break after a sec or too of cutting alu, or need 9 to cut a circle
Ah, get the cutting kit. It's got three discs in it that are made of abrasive ceramic and reinforced with fiberglass, as well as quite a lot of ceramic cutting/grinding ceramic discs. For $10 USD, it's freakin' amazing. I cut everything on my case with the fiberglass, including the hole in the top of the case and there's no visible wear on the disc at all. You can also try the diamond disc, but I don't have it myself. Here are the links: Fiberglass Diamond
ok here I go again.. I've been on a machine shop a while ago to buy some aluminum sheet but they dont have any stock so I buy this allen screws and nuts i also got a lock washers. who the !@#$ is this? LOL hmmm looks good.. i think its better to use black allen screws than stainless screws. Check it out. 2 holes I found out that the holes are not fit and inlined to screws. so better to make a hole again. that's it!
finally I finish the front skeleton system of this project. I need to make 1 more for the rear panel. cut This picture is to show up to you guys how mess my modding room.
here's a short update again. remember my goggles with holes? now i get some acrylic to put into it. I call this a DIY Goggles! lol! here we go. Combining them to sander it. I go to the hardware and buy this stuffs. sandpaper and the stainless cleaner and polisher
Need to cut this out. preparing look out... what happened to my cutting disk! I just cut some edges on the aluminum bar.
