Case Mod - Complete NEW Antec P120 build fully watercooled

Hey everyone, I am back with a quick build log.

Antec asked if I could do a build in their new P120 case and this is my journey.

The parts I will be using are,

CPU - AMD 2700x

GPU - ASUS Dual RTX 2080

RAM - 16gb 3200 mhz Thermaltake WaterRam without the waterblock

Motherboard - ASUS ROG Strix X470 - F

Storage - Adata SX6000 256GB M.2

PSU - Antec 650W high current gamer HCG

Fans - Antec Prizm 120 ARGB

All the water cooling parts were supply by thermaltake and I manufactured a custom distro with integrated ddc pump for this build.

This is the case.



I stripped the full case down and drilled all the rivets out as I want to paint the full case a gloss black with red splash. this would be the biggest part of the build.


Before,




After,



Once the painting was completed I needed to test fit all the parts and plan the loop and get the holes for the front distro.



This will be my 1st build where I will be using a DDC pump in the distro plate, I was not 100% sure on how to do this but a did find a guide on the bit-tech youtube channel which helped a lot thanks Alex.

This is my design for the front distro.



Now time to cut the part.

 

Once I cut the part, I needed to test fit the part and leak test it, I couldn't find my leak tester, so I just filled it up.





We did have any leaks so it was time to add it to the build and run the tubes.





Time to fill her up,



Just want to say a big thank you to Antec for letting me build in their new P120 I was really surprised at how much room was in the case and a big thank you to thermaltake for supporting me in this project.

If you have any feedback leave a comment below.

Here are the final photos.

 

First of all, what is sick. You're work is amazing man.
Question about the waterway/distro size. What is the exact size that made it fit perfectly?

 

hey thanks, not sure on what sizes you want, I made a custom bracket to attached the distro to the front.