I know this has been covered many times, and I had one running great... But... had a small incident and killed the screen on the old one! :duh:...
I know you can run two raid cards for duplexing... But, What about running one RAID adapter and one Standard adapter? Would be on two...
If I use a 4 pin molex from one PSU to trigger a Second PSU will they still be isolated from each other? Or will they both share a ground 0v?
Anyone recommend a good source for rotary tool cutting discs etc and case rivets? Places I've found only seem to stock rotary accessory 'packs'...
I'm in awe at the quality and imaginative creations in all the new projects that have been started recently. Which has finally given me the...
As title... carrying on from my 'Case improvement' thread... I've got an idea to solve afew problems I've encountered, but need some advice on the...
Where can I get a IDC crimping tool? Maplins used to do one, but as with everything else useful... they've discontinued it! :rolleyes:...
Could this not do it? Parallel ---> USB convertor http://www.dontronics-shop.com/home.php?cat=322 The U401 and U421 USB interface The...
Got this this morning from veryevil... [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] Now all I need to do is mount it into the top of my case!...
Well it's about time I revamped my case, a Cheiftec full tower... Was thinking along the lines of replacing the 5 80mm fans with 92 or even...
Picked up a Asus FX 5800 with a Zalman heatpipe cooler and fan... BUT it won't fit in my rig as the CPU hsf gets in the way even with a 60x60 hs...
Following on from a previous Thread I put up asking about DIY pcb's and laser printers... It all began when I came across Turbokeu's site and...
Due to one of my design's I need to mount a pcb I've etched upside down! :wallbash: Basically I know the diodes, resistors, Capacitors, and...
Right got some 3mm red LED's I'm planning on using in a baybus I'm building... Just want to double check I've worked out the right value for...
Can u use a inkjet printer with the Press 'n' Peel sheet's? Really want to finish a circuit I've been working on but abit apprehensive about...
Separate names with a comma.
