the loop (reservoir/pump combo) was designed to operate in a horizontal or vertical manner though I prefer the vertical look. From the readings...
Big update and finish... for now. I know, I need to fix the wiring. That's an eventual plan. =) [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]...
a little update since getting last week's shipment of goodies... though I had to order more due to changing plans (again). [IMG] [IMG] [IMG]...
I know what you are saying but that is not entirely true. I've run reservoirs at a low point before without any issues. Just wait and see. =)
Okay, maybe I didnt have to bring out the tape measure since its fairly easy to understand that a 4 x 120 radiator is pretty darn long for most...
1/2", well... Kinda. The 4 sides are made up of 3/8" acrylic with 1/8" panels cemented together. This was done so I could create some channels for...
I've got to tell you, its taken me a long time to get to where I am currently at with this little project of mine (and countless dollars). I was...
So.... I'm going to be doing some updating in the (maybe) near future due to getting the R4's big brother. This will allow me to better design...
[IMG]
Okay, its been a while since I mounted the second radiator and cleaned up the tubing. Thank you Aquatuning for getting those 90 degree fittings...
The fan grill is done for now. If I try this again I'm definitely working with 1/4" acrylic rather than 1/8", but I'll use this for now. [IMG]...
Little update March 25 So, after a few months of searching and being a little unlucky in sourcing a second Airplex Evo 240 I just decided it was...
[IMG] [IMG]
Im going to do a little painting on the ring for the Gentle Typhoon AP-30 to give it a more pleasing appearance, a corsair look alike. =) [IMG]...
We have some local stores called TAP Plastics out here in California, lots of stuff there... =)
I decided to make a fan grill for the exhaust ports. It matches the exterior front panel for the case. I used an old AquaComputer Airplex radiator...
I've been wanting to order from Nils & MDPC but the timezone difference is getting the best of me. I'll get around to it someday Im sure, I just...
I cleaned up the wiring in the back [IMG]
Got the pump cover midplate finished (for now). I used two 1/8 acrylic sheets sandwiched and glued together. It just drops into place and allows...
Just an updated glamour shot. Im test fitting the pump cover (mid plate) so I can decide what adjustments I need to make. [IMG]
Separate names with a comma.