This project is pretty much done!!! I ended up staying up late the night before I left to finish leak testing everything. But I got it done....
I used an acrylic cutting knife, a routing table, and a few different files to make the bottom acrylic piece. It isn't illuminated, although I...
Woooah, it's been 4 months? I apologize for my extended absence. I've been getting ready for college and now I'm working an almost full time...
I wish I could, but everything is pretty much set in stone for straight graphics cards now. So, it's gotten into the 70s here and I'm still...
You have no idea... Yea, funny story about that. I meant to order the smaller 3/8x1/2 size, but I gave the wrong part numbers to Bitspower, so...
Yup, that's with the SLI 770s. Now that I think about it, I didn't have the RAM block hooked up, so that may be a factor, but I imagine it...
Alright, I'm back in business! Sorry for the long wait. College stuff, school, and robotics have been keeping me busy. Anyway, on to the...
Looks great, can't wait to see the next update!
I've had all of the hardware set up on a bench till I needed it for measurements recently. I've done quite a few gaming sessions and Seti@home....
Oh, lol. It was totally going over my head why jamsand said ketchup :duh: I did use distilled water in the loop, but I didn't flush out the...
I'm on a roll now! Finals next week, then I'm free to work on this project all day long. I'm hoping to have it completed by new year, so expect...
Quick little post before I leave for Nebraska for Thanksgiving. Alongside the coming acrylic work, I have begun sleeving my PSU! [img]...
I'm not exactly sure what you mean, but the GPUs should fit. The I/O slots are lower than they were with the 45 degree mounts, so I'll have more...
Can't wait to see it!
Got a bunch of case work done. Pretty much finished with the basic metalwork now. I cut out two metal strips and then bent them to use as...
I'm diggin that leather a gold look!
Alright, I've got some good news and some bad news. Bad news is I've tossed the 45 degree cards plan. Unfortunately I still just couldn't get...
I really like that solid wiring. Great idea!
Well, turns out the motherboard still isn't working, so I'm going to try adding more power to the extenders and see if that helps. If not, I'm...
This project isn't dead yet! I've made a major breakthrough! :clap: I just got my ASUS motherboard back from it's RMA and after a little...
Separate names with a comma.