Haha, you aren't far off. I've deviated and updated so many times compared to when I started this log. I sometimes feel like I really shouldn't...
Uh, it's been a while since I've made an update. Almost 4 years? It doesn't seem possible. Of course I got sidetracked again. It's now been long...
Believe me, I know as well. I've always been busy with a project of some kind, even if it wasn't related to computer modding. However, I've now...
Thanks! Yeah, progress is still a little slow, but it is progress just the same.
Nice update man! Very tidy with the loop and wire routing. It may have taken you a few years to get here, but it's been worth it!
Thank you! I also think it's aged fairly well, but there's no doubt it's a bit of a departure from most of the mods you see here.
Sure, why not? Haha, nothing is safe! It it exists, it can be modded.
Since a HDPlex 400w AC-DC will be used going forward, I decide to design an external 'case' for it to match. The design should allow for adequate...
I've seen a few home brew SLS, and it would definitely be an epic worklog. I'm not sure the print quality is quite there yet compared to the...
Thanks! It was obviously long overdue. I've been feeling the modding spirit lately, so I figured I'd take the time to write it up. Yeah, I just...
Thanks guys! It's appreciated!
With CPU magazine and it’s online presence now gone, here are all the final build pics of the project in no particular order.. [img] [img] [img]...
Let’s finally mate the core and shell together. [img] [img] [img] [img] [img] [img] [IMG] [IMG] Now where does this leave us? Due to great...
One of the best parts of the core and shell design, is that I can actually paint the exterior while using the fully functional core. [img] [IMG]...
With everything now cut and test fit, it’s time for paint and final assembly. [img] [img] [img] [img] [img] [img] [img] [img] [img] [img]...
It’s finally time to flesh out the side panels. I cut a few pieces of acetal for spacers, and then cut and bent the aluminum panels. Any time...
Let’s see how this all fits together! It’s looking pretty good at this point. [img] [img] [img] [img] [img] [img] [img] [img] [img] It’s time...
Everything before was leading up to this, the most complex part of the build. This is where symmetry comes in handy. The left and right side of...
With the core essentially complete, it was time to work on hardware positioning and layout. [img] [img] [img] [img] [img] [img] [img] [img]...
With the largest parts of the core covered, let’s move on to a few of the smaller details. It was some time in 2010 that I first saw the Zalman...
Separate names with a comma.
