Been a little caught up the last week or so and haven't been able to to get much time into this project. But most of the leds are in and i am back...
small update steady progress. got the white leds in the case. i put it back together and checked the look out. [IMG] [IMG] [IMG]...
great build. with the paint...your temps are a little on the low side but are workable , you might want to try warming your cans of paint up in a...
thanks :thumb:. ive always been impressed with thoroughness and out the box thinking in builds, still got alot of small thing to do. i got the...
thanks man, definitely more soon.
small update. steady progress. i got the psu all sleeved and ready. i went with paracord because the sleeving from the kit is see through. i...
small update. steady progress. fixed the res, no leaks. the rad is good as well. the cpu block i reworked because the fittings were touching...
Thats gangsta :thumb: :D
small update, steady progress. i leak tested the loop. i thought i might have problems with the block but it was the left side of the reservoir...
assembly commenced. i attached the frame to the top panel of the case. [IMG] [IMG] [IMG] [IMG] [IMG] the feet. [IMG] tops of...
"Every day above ground is a good day." -Tony Montana too much pressure on the drill tends to crack plexiglass. so....... [IMG] started...
small update. steady progress...... bout 85% done with the block, still need to drill and thread the fitting in as well as the bracket holes. then...
small update. steady progress. got most of the work done on the pump. cut the tank down to size, attached the bottom, drilled and counter sunk...
re-sprayed everything................ [IMG] [IMG] the cooling....took everything apart. the copper plate. [IMG] [IMG] [IMG]...
the motherboard tray. the case has a couple little tabs that the original tray hooked into. the drive cage is made the same way. i started to cut...
top case panel sanded down. [IMG] sprayed it and the frames. [IMG] [IMG] [IMG] [IMG] more soon. thanks for looking.
small update. steady progress. got all the frame pieces wet sanded 2000 grit sand paper. still had a few rough spot to work out. probably going to...
thanks Darkwisdom. tonys office was a pretty busy place and a little over the top :) . [IMG] after i sand and polish the initials up ,...
got the front intake bracket pretty much finished. counter sunk the screws the attach to the out side frame, added a few holes for leds later....
this was my personal rig, i ran it in my living room as my htpc gaming and workstation. i had a 48" tv and two 22" monitors hooked up to it....
Separate names with a comma.