Well. Wasn't that foretelling? I didn't finish it that Summer, and as predicted studies didn't allow me the time to do much more - well, the main...
Well that's funny, I was reading this hoping for some advice on what to upgrade my Q6600 to! Been out of hardware for a while (stopped CPC sub...
I read it on reddit, from a guy who know's a guy, or at least knew his online personality for a few minutes. It's definitely legit.
Yup, I agree. As a student, I've never really seriously considered a career in chip design (or rather, considered and quickly dismissed) - but...
You just have to bite the bullet. If you look back to the start of this thread, you'll see I've been at it ages - not in terms of time worked on,...
Thanks :) Broke the Dremel out again today (okay.. so I didn't exactly put it away..) and the PSU now has a rather neat enclosure/holder. [IMG]...
Holy ****.
Both fan mounts now complete. I laid the hardware out inside to get a feel for spacing inside this afternoon - tighter than planned around the...
Ah yeah maybe. Might've just filled in 'profile' or whatever saying your 18. I know GiffGaff explicitly ask you to opt in to 'Adult Content'. I...
I hate to insult your intelligence.. but you definitely had WiFi off? Most of them do I think. EE, someone else said Virgin, GiffGaff do...
Cheers both of you :) Yeah, I hope temps should be okay - it's not too deep (I realise there's not really anything in the picture for scale),...
You all must think that the project - or indeed I - has died between each of my updates..! It's a slow burner for sure, but I want to do it...
Thanks all for the kind comments, I'm sorry not to have updated in a while, exams -_- My last one's tomorrow, then I can get back to it :dremel:...
Well, my Dremel 4000 arrived! :dremel: I fired it up this afternoon and had a bash at the trays to hold the fans, first of all using a cutting...
Cut the other side today, worked like a champ, no issues at all this time, so I think the detachment last time must have just been an issue with...
First fan hole done today - using a pillar drill at school which is continuously variable, unlike my five-speed, which only goes down to 545rpm....
Thanks for that Waynio, I wish I'd seen that video earlier - he makes it look easy! I wouldn't have worried if I'd seen that. On a metalworking...
Thanks Waynio, though that's not what I wanted to hear! :hehe: I wish I had just bought a dremel and circle cutter sooner, now that I realise...
Good news for the fan hole - the resistant materials department at school has a variable speed pillar drill (unlike my totally mechanical, with...
Back to brushing, here's the pictures of setup I forgot to post the other day: [IMG] [IMG] Basically I just taped the sandpaper (grades...
Separate names with a comma.