bit-tech.net Forums - View Single Post - Scratch Build Project - OBSIDIA-Shiro - UPDATE:Project Completed, finished the laser cut madness

KryptiK · 11th Aug 2012, 08:45

Another update!

Today I was mainly gluing brackets to components. The 3mm sheet was bolted to the bracket and the bracket then glued like so. The fan grill panel was aligned to the corner.

This part was kinda fiddly to get the bracket aligned perfectly parallel since it was basically floating around (besides the connection to a parent part).

Since I didn't have any more 6mm white acrylic i used two sheets of 3mm bonded together. Not sure if this part will bend properly with a heat gun.

I'll try some bending tomorrow

11th Aug 2012, 08:45	#10
KryptiK Minimodder Join Date: Jan 2012 Location: Sydney, Australia Posts: 43	Another update! Today I was mainly gluing brackets to components. The 3mm sheet was bolted to the bracket and the bracket then glued like so. The fan grill panel was aligned to the corner. This part was kinda fiddly to get the bracket aligned perfectly parallel since it was basically floating around (besides the connection to a parent part). Since I didn't have any more 6mm white acrylic i used two sheets of 3mm bonded together. Not sure if this part will bend properly with a heat gun. I'll try some bending tomorrow