I'm going to be getting the old dermal out on my mates case as his new GPU is to big for his case. the power cables stick into the side panel stopping it from closing. so was going to cut the side panel so the cables can poke out a little. so it don't look a mess and to help the cables from not getting cut im looking for the rubber grommet used in cable management holes in cases or something similar. Just a strip of rubber that can slip onto the metal will do. any help?
ooow, looks like what i want is U-channel edge strips. any other advise would be good tho as iv not done this before but should be simple. http://www.ebay.co.uk/itm/Neoprene-...153?pt=LH_DefaultDomain_3&hash=item2ec6dce9c9 Like i need to know what the best dremel disk to use will be, also will i be able to cut a shape like this with one.
Yeah I've just bought some on eBay too, if the panel is perspex I would probably heat it and bubble it so it clears
dont have the bits needed and dont want to buy them for this one little job but will ask about if any of my family have them. its going to be 1.5" by 2". sure you can do something so small with drill bits?
As you said, if it's metal, you could draw out the shape, and drill round the edge with small bits and either jigsaw it or break the part out with a file, The rubber strip will hide any small imperfections.