Cooling Rasa CPU block

Has anyone used this block is it worth me changing from my V3 to this for better mounting?
I think reviews say it beats the Heatkiller.

 

which review were you looking at in particular ?

I also have a heatkiller V3 block and been pretty pleased with it.

 

Sorry i wasn't clear I currently have the XSPC Delta V3
and here's the review I looked at: http://www.overclockerstech.com/xspc-rasa-cpu-water-block-review/1/

According to that the rasa block beats the Heatkiller V3 by a few degrees.

 

The EK Supreme HF is also worth a look http://skinneelabs.com/ek-supreme-hf.html?page=1 but note that you have to change the internal restriction plate for best results.

 

The Rasa would be a step in the right direction

 

Thanks Nitrix, gonna look into it.
Is there anything else in that that you would recommend over the Rasa?

 

sorry accidently double posted...

 

http://skinneelabs.com/koolance-cpu-360.html?page=5

 

^ theres your answer

but bang for buck the Rasa is a good bet.

 

Also check out this mod. It got me just under 2ºC improvement but took me a few attempts to get it right as I found it difficult to use small amounts and keep it smooth. I used the silicone sealant you use for sealing sinks and baths. One warning though, leave it a few days to set properly. On my first attempt I just left it for 24 hours and it hadn't set fully and was a real pain to remove from the micro channels.

http://skinneelabs.com/heatkiller-i7.html

 

nice link - that could be something to have a look at

+Reps