Project Maximus Design Decided to take on a new project for two reasons, firstly it was time to replace the fluid in my system and give all the parts a good clean and secondly i saw the new Fractal Design Arc Midi R2 and new i needed it!!! To cut a long story short i have also ended up with a new motherboard, new pump, new fittings, new fans etc. To make these purchases i have sold a few parts i had left lying around and once i replaced the system i will have more bits to sell! New parts are: Asus Maximus Gene V D5 pump with Bitspower mod kit and pump top Bitspower Blood Red Barbs Bitspower Matt Black D plug Mayhems Black Pastal Fluid 6 Corsair Hight pressure low nose fans Xspc Tubing Fractal Design Arc Midi R2 (when it is released) Existing Parts i am re-using Ek supremacy cpu block i5 2500k 2 Evga 570 SC card with Full EK water blocks and backplates 1 XSPC rs 240 rad 1 XSPC rx 240 rad XSPC Bay res and custom white faceplate Corsair AX850 psi with White braided cables 8gb Corsair Black LP memory 8gb Corsair Red LP memory[/FONT] I have spent today draining my rig taking all the parts out and giving them a good old clean. Not much i can do now until i get my hands on the New Fractal Design Midi R2, still waiting on a release date. Im going to take loads of pictures tomorrow of all my new and cleaned equipment as. But here is a teaser
As promised here are some pictures Let start with some more motherboard pics. Some GPU shots. Both are evga 570 superclocked editions, had them for a couple of years and they still destroy any games, with the full ek blocks, they look so much nicer than the new circle design in my opinion. My Faithful rads and my XSPC bay res with custom white facia. Cosair AX850 with white sleeving New D5 pump with bitspower top and mod kit. I sleeved the cables but they wouldnt fit through the holes at the back so may just leave the cables as they wont be seen in the build anyway. And last pictures is for the wife really
Nice collection of parts. A bit premature posting a build log for a case that isn't release yet? Either way I'll pop back in and take a look when it starts coming together
Nice parts mate! Though I agree with Elenos, it's a bit early to post a build log and have to wait for an unreleased case before starting.