I'm sure I read that you can. Thing is I am worried about cutting them in the wrong place and killing them. So can you? and if so if I upload a pic could some one tell me the cut points? Cheers
Yes, typically you cut them at the gold connectors (then strip the plastic sleeve off at those points) and solder or use one of these: http://www.theledstore.co/led-strip-connectors-FSCT-010%20RGBW?gclid=CKe-1o6eps8CFegp0wodUOECSg
Mine are not like that fella. I will try and get a pic of the back side/traces tomorrow. They were like £1.12 for two lol. IIRC it's three LEDs per resistor, so it should be manageable.