Modding Dremel cutting disks supply.

Anyone got a link to cutting disks that do not break when you show them a bit of metal. My too is actually a Draper but same idea.

 

Surprised at the amount of views yet no suggestions. Bought some from the bay as I have three screws that I need to slot asap.

 

Have you tried the reinforced ones?

Reinforced discs

I've had the general use ones shatter and go off like bullets, not had one of these do the same yet.

 

Save a sheetload.

http://www.ebay.co.uk/itm/100-REINF...286?pt=LH_DefaultDomain_0&hash=item4ad1ba7b36

But don't forget to wear safety glasses just to be safe, cutting discs love shooting towards the eyes, reinforced ones are less prone to it but still wear the glasses, I had some lucky misses with blinking at the right time.

 

Cheers guys.

 

The reinforced do shatter at times but it's rare. At my mother's house there are small shards of the non reinforced wedged forever into her dining room wall

 

The reinforced quicklock disks are amazing but more expensive than the normal disks by some margin.

 

BTW Glenn.. If you're cutting acrylic buy these.

http://www.amazon.co.uk/Silverline-...94443751&sr=8-1&keywords=diamond+cutting+disc

For the simple reason that they pretty much last forever. I bought a pack over a year ago and I still haven't changed out the first one I fitted lmao.

They're about 1/3 as thick as a reinforced and are metal based. They go through acrylic like a hot knife through butter mate, an essential for the PC modder.

 

Bought some ordinary reinforced and a few quicklock to try.

And it is metal Andy but will keep those in my Amazon wish list for future reference. Thanks.