Hello everyone. I would like to share another casemod I intend to do. The allotted time for the finish is a little short, but try to do everything possible to finish in time.this case will be shown in the HyperX booth at Computex in June. Thank you in all my sponsors, friends and family for your patience and for the opportunity to build another case. Sponsors The pHardware that I will use for this project A small gift won from HyperX and kindly received tools from Dremel The case chosen this time is the Cooler Master Trooper acrylic with contact paper
hiding that angular bend on the front mesh is such a shame! but then again, all those layers and stuff you have going on is kinda attracktive too...
Thank you friend. I did so to better show the format of this case. I thought one of the most beautiful so far I've done I would like to thank everyone who has accompanied this project.Actually I had little time to finalize and had not enough time to be able to take final photos of this project. He has been sent to Taiwan to be shown on the stand of HyperX. in sequence the photos of the project Parts kindly sent by Bitspower Riding the water cooler system I hope you like the end result, Many thanks to all sponsors, friends and family and everyone who followed this topic