looks good dude, see what you mean about the top panel being in two sections and by chance where any of those photos ones you where trying to show me, also the case is HUGE!
Just hit a snag, was trying to remove the rear fan and the 2 bottom screws are in insanesly tight, as I've managed to strip the screw heads boll*cks!!!!!
oh bloody hell, why where you removing the rear fan anyway, where you going to braid the cable from that as well or something ?
Yeh, I was going to braid it, no nasty cables... I may just have to do it while its in the case now unless people have suggestions...?
Just braiding various cables, and I've come to the front pannel audio cable. Question is, do I need the ZC'97 connector, or can I simply cut it off?
Does the braid fit over the connector when you pull it back in line with the other cable? (assuming its like this..)
Where is the port on your motherboard? On my P6T its right along the bottom edge(which I think is standard). Also my utgard has a little hole just under the motherboard which I use for this purpose. In my case(no pun intended), The bulge would not be visible.
Personally I never bother with the front panel audio connections anyway and just cable tidy them out of the way, the Aego M's have a headphone jack on the sub so I use that Are you fretting about your nice shiny new case already Pete??? You've only had it 5 minutes
Gah, why didn't I think of that??? My SP2500's have a headphone output too!!! Urg! And you'll love the cable management I've done so far...