Case Mod - In Progress My Glass & Steel Orange Graphite 600T

Nice!

 

Thank you Nut!!!

 

Wake up early today, I reinstalled the trays after being tapped for good and satin with fine sandpaper.
This time I put a dot of glue between the glass and gasket just to hold it against the glass.
I reinstalled the SSD with the pieces reduced and the new mask for filters Aquacomputer: receipts for the filters are able to reconstruct the millimeter and filters fit like a glove.

 

Fantastic work Dave! I really do love the reservoirs, you should look at selling them .

 

Eheh thank you very much!! I'll think to sell them

 

Mmm, the mask of Aquaero, it's better black, or steel?





What do you think about?

 

I like the raw front on the aquaero, helps it blend in. Considering the other aqua computers controller is black though it doesn't look too bad in black either.

 

Yup, I think the raw front works best in this case, too.

 

Steel, but why arnt yopu doing a faceplate in one big piece with cutouts for all of the other panels and accessories ? would be so much nicer !

 

I wish i could afford two of those pumps! May i ask what the diameter of the mounting plates is? Looks great so far!

 

Thank you guys!!!

I thought about it, but I had problems with the fittings inside the case.

What diameter do you need? I don't understand.

 

Good morning guys, I fixed the glass of the pumps. The glass is fixed with silicon, and it's very strong. In the week I hope that the Aquacomputer waterblock for the GTX670 will arrive, to start mounting the liquid cooling system.

 

Im really liking that front panel design

 

Thank you Mankz!!!

 

wow...

I just LOVE the look of that glass... it's really unique! Great work...

 

Thank you jokkos!!!

 

i believe you are going to paint those metal pieces from front and inside cause then that would look bollen! (i don't know if i said that right) but looking really good

 

No, I won't paint the steel, because I like too much the steel color! The name of the mod is Glass&Steel, so I must keep the steel color of the panels. Also, I think that I'll paint the passive radiators with opaque black.

 

Sorry i didn't clarify... I mustve wandered off in my thoughts ... not an unknown occurance with me

I meant to ask the diameter of the outermost plates for the resrvoirs... Working on something similair and I can't seem to get the proportions of the diameters to look just right... Even with two top of the line 3d programs on the same rig it's driving me nuts!

 

Ooook no problem man!!
Ok the diameter is sixty millimeters