One part from Bykski block make PCB bent so I must cut it, new revision of this block dont have this problem. This show how I can remove Front Radiator I changed fans on top radiator. Arctic P12 have same performance as PW2 but are much more quaiet so now I have same noise but highe rrpm and performance. P12 can run on 850 rpm and give much more static presure than pw2 on 650 rpm with same noise. I bought bykski's GPU holder but I must cut some parts if I want to fit it.
But what do you mean? Bykski holder or copper element in water block? If you have meane element in block which i cut off It was easier to cut off the disturbing element and make it look right than to do it from scratch. If you have mean VGA holder I must say that I don't have enough time to do elements right now, bykski was very cheap and solid, I must only cut it a little bit.
Ok Project is finally done! I OCed my G.Skill Trident so cooler was necessary (3800 15-15-15-36-1T, 1,43V) Of course big thanks for my little fluffy friend which stole me a lot of screws