Prometheus

My 3D printer project

Sort By: Comments

Sort By...

Filters

Type Filters

Small flats were ground on the shafts of each motor to give the bolt something to stick to
Sea Shadow

Sea Shadow

Prometheus

Small flats were ground on the shafts of each motor to give the bolt something to stick to

0
54
0
04 Sep 2010
Each of the gears has a trapped nut to hold the gear in place
Sea Shadow

Sea Shadow

Prometheus

Each of the gears has a trapped nut to hold the gear in place

0
52
0
04 Sep 2010
Nema 17 1.8 degree stepper motors
Sea Shadow

Sea Shadow

Prometheus

Nema 17 1.8 degree stepper motors

0
65
0
04 Sep 2010
I have added the lead screws for the Z-axis and installed the X-axis (it was upside-down when I took the picture)
Sea Shadow

Sea Shadow

Prometheus

I have added the lead screws for the Z-axis and installed the X-axis (it was upside-down when I took the picture)

0
54
0
03 Sep 2010
Time to square up the each axis and add some loctite
Sea Shadow

Sea Shadow

Prometheus

Time to square up the each axis and add some loctite

0
57
0
03 Sep 2010
All bottom rails have been installed
Sea Shadow

Sea Shadow

Prometheus

All bottom rails have been installed

0
55
0
03 Sep 2010
Alternate view
Sea Shadow

Sea Shadow

Prometheus

Alternate view

0
62
0
03 Sep 2010
Now some of the center supports have been added, they are needed since the Z-axis belt will be tensioned right over that area.
Sea Shadow

Sea Shadow

Prometheus

Now some of the center supports have been added, they are needed since the Z-axis belt will be tensioned right over that area.

0
54
0
03 Sep 2010
The back rails have been added. If you look closely you can see where the motor for the Y-axis has been mounted.
Sea Shadow

Sea Shadow

Prometheus

The back rails have been added. If you look closely you can see where the motor for the Y-axis has been mounted.

0
54
0
03 Sep 2010
Sea Shadow, 30 Jul 2010
Page 18 of 27
    There are no comments to display.