Prometheus

My 3D printer project

Sort By: Views

Sort By...

Filters

Type Filters

Bearings keep everything rolling smoothly
Sea Shadow

Sea Shadow

Prometheus

Bearings keep everything rolling smoothly

0
60
0
05 Sep 2010
Assembling the pieces together
Sea Shadow

Sea Shadow

Prometheus

Assembling the pieces together

0
60
0
19 Aug 2010
The large mudguard/fender washers function as guides for the belt that will be running over the bearings (under the washers)
Sea Shadow

Sea Shadow

Prometheus

The large mudguard/fender washers function as guides for the belt that will be running over the bearings (under the washers)

0
60
0
03 Aug 2010
Almost done with the assembly
Sea Shadow

Sea Shadow

Prometheus

Almost done with the assembly

0
60
0
03 Aug 2010
They will be used to hold the corners in place and keep the enclosure top from sliding around.
Sea Shadow

Sea Shadow

Prometheus

They will be used to hold the corners in place and keep the enclosure top from sliding around.

0
59
0
22 Apr 2011
I am using my laptop to generate and stream G-code to the printer. I will have to slap together an old computer for the task later on.
Sea Shadow

Sea Shadow

Prometheus

I am using my laptop to generate and stream G-code to the printer. I will have to slap together an old computer for the task later on.

0
59
0
06 Feb 2011
My A-frames only had 2 support clips, and I needed 4. That's easy enough to fix.
Sea Shadow

Sea Shadow

Prometheus

My A-frames only had 2 support clips, and I needed 4. That's easy enough to fix.

0
59
0
06 Feb 2011
This picture was taken after a few trial runs, the yellow plastic is some print material that fell down inside and I haven't bothered to take apart th
Sea Shadow

Sea Shadow

Prometheus

This picture was taken after a few trial runs, the yellow plastic is some print material that fell down inside and I haven't bothered to take apart th

0
59
0
05 Feb 2011
The scorch marks are from a lighter that I used to soften the plastic.
Sea Shadow

Sea Shadow

Prometheus

The scorch marks are from a lighter that I used to soften the plastic.

0
59
0
05 Feb 2011
Sea Shadow, 30 Jul 2010
Page 19 of 27
    There are no comments to display.