good, i checked the UBW thingy its good for what ur trying to do.... although its a CDC class it should work fine but u need the driver.
i guess i have seen some something similar to what you described somewhere sometime ago. anyway its not hard to DIY. simply get a USB enabled...
microcontroller's output usually can supply a max of 20mA at 5v. capnPedro solution is best and should work with no problems. u could use any...
the circuit is a bike POV and the LEDs are individually controlled by serial to parallel shift regs.. and all the common ground connects to the...
hello all i have 30 RGB LEDs that i want to be able to switch them using a transistor. all leds are connected in parallel. now if each RGB...
many new optical mouse that i saw dont use optical detection of scroll wheel, they use some sort of mechanical rotary encoder. ur best bet is to...
it would be more advance and much nicer if u could substitute the knobs with capacitive touch sensing pads with a cool plexi and lightningjust a...
hi albo is it really convert dc-dc ? i am abit confused bout this two lines # AC Input Voltage Range: 85-264VAC (120-370VDC) # Input Frequency:...
http://led.linear1.org/led.wiz check that wizard out..
problem solved !!!! the circuit board that the servos connects to didnt have a common ground with the PIC18F4550 controller board. can you...
hi everybody i have this problem i couldnt tackle, i am building a mini robotic arm it has 3 servos to do 3 DOF. one is futaba, one is JR,...
hi DanielHB try to make sure you are receiving a pulse train out of the output pins, you could use an oscilloscope or a pickit2 if you have...
hello everybody i made a PIC18F4550 board which controls 2 motors they are from the AXH series made by oriental motor. the issue is the 4550...
Separate names with a comma.
