[IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] [IMG] There were budget restrictions hence there is no 2nd PC in it at the moment....
After that i had to go over to his place a LOT of times to finish up. And the part we have all been waiting for. (sorry i am a terrible...
All ready to be shipped over to his place for the completion. [IMG] [IMG] [IMG] [IMG] [IMG] final picture with it in my room. [IMG]
The front IO had to be matched to the rest and so i roughed it up first [IMG] Then polished it [IMG] Used four 3" steel hinges to attatch the lid...
Dry fitted the top again to check clearance. The acrylic has also been cut to size. But not shape [IMG] Acrylic mounting holes drilled. First...
The mesh It came out nicely after painting. [IMG] Putting the top lid on to check fitting and also to take measurements and cut out the acrylic....
Finishing off the power buttons If you had noticed earlier, i haven't wired up the power and reset buttons on the front. The lian li uses an...
Bending The Perforated Sheet. Material - Stainless Steel Mesh - 1.6mm holes The reason why i bent it is two fold. 1. its springy and...
Hi there. Integrating the I/O with the front and side I would be using the lian li's I/O on the front. marked out [IMG] I got some...
Thanks for all the support! I hope ill meet your expectations! contest deadline is 6th june :S wasnt making this for the contest originally. it...
Woke up at 8am to start working. Hello old friend, we meet again... [IMG] looks to be in the order i left it. [IMG] Matte finished the...
Yes i am very much alive! And so is this project! Sorry i was away because of my final semester in engineering... Now thats been done with, LETS...
had to work my ass off with hand tools before i could buy my own!
long time no see, yet again! as usual click images for bigger resolution since some of the rails i used were new and unused in the rosewill...
~click images for higher resolution~ Long time no see... time for a weekly update. first i had to adapt the hdd easymount mechanism onto the...
Separate names with a comma.