Noise is very low, they work well on a controller. I actually had two on a XSPC 240RX Rad which is about 50mm thick and was seeing 32-34C on...
The only ones from your list that I have used are the scythe slipstream's. at 12mm they work remarkably well pushing but get caught on the rad...
This is certainly one of the best test bench's I've seen! Well done!!!
UPDATE!!!! Here is yet another update. Things have been going fairly well aside from a few set backs. First off my heat gun went up in smoke......
Thanks! I'm near 95N and Ann rd. a little bit north of you. The EK pump top already comes predrilled for LEDs which is way nice! The only thing...
As a fellow cycling fan and modder, I look forward to seeing the progress of this build!! Sub'd
18DEC12 Update Hello all! It's been awhile since my last update. I've been very busy between work and the project. I have made quite a bit of...
I love the wave of Prodigy builds!!! It's such a great case with so much potential!!! Looking forward to the progress of this build. *sub'd*
Darn that would've looked sweet! Ya I don't know what I would do without a heat gun on this stuff lol
Yea for sure! It goes with the window trim as well!!
Bro those 280 shrouds are awesome for this case! I'm doing the same thing for the sake of space and believe it or not, they wrap pretty well with...
Haha props to you man! Ya I've wanted to do a mITX build for a long time but couldn't justify buying a new CPU after just buying a 2011 socket...
Love the use of the mesh! very nicely done
That's an awesome design man! I wonder what the hexagon would look like if you drill 5mm holes in the bottom of the plexi where it won't show for...
Yep you sure can! You can get MOLEX (.093) sized male and female connector pins from some local electronics stores or order online. The ATX pins...
Separate names with a comma.
