Answer to the question "can it be done?" is yes. You can see some pictures of a USB interface board for a compatible display here:...
You could try to use some logic circuitry to do the refreshing and driving the control signals. Use some programmable logic like CPLD or FPGA or...
So were you planning to connect the RAM DOUT pin straight to the display and then drive the RAM address and read strobe lines and the display...
How were you planning to handle the rest of the controlling logic ? Microcontroller, logic IC's, CPLD, something else ? Maybe you could use 8- or...
There are some at http://www.skippari.net/lcd/ :D
Well there must be some reason why the capacitors are put on the pcb. I'm quite surprised that the circuit would work even at those speeds without...
I think he means the wiring usually used with LPT port connected KS0108 displays with "standard wiring". Thanks Hazer for that datasheet. Now...
Ok I also checked Bolymin site for any information about this display and found just the same PDF there. Maybe you could email Bolymin and ask for...
That one looks very nice. I've been thinking if trying something similar but maybe with FPGA and driving the LEDs with PWM to get different...
That doesn't look like KS0108 to me. Do you have more complete datasheet that would also show the commands used to control it ?
I should have written some more information last time but I was feeling tired and then only posted that link. As your display takes the data in...
Something like this ? http://forums.bit-tech.net/showthread.php?t=83847
In the picture of the board with the HD61830 controller and RAM on it you don't show the whole board. Is it only a small part of the board that is...
Ah, if you have it wired so that the reset is normally at +5v (through a pullup resistor 10K or something like that) and the button just grounds...
As you have the contrast working now I suggest you leave all the power and contrast wiring as it is and only rewire the connections between the...
Separate names with a comma.
