Hi, Thanks for your interest. I now rarely check this thread, sorry for my late answer. I was not able to find a solution. I tried it hard, no...
I used some parts of the original mounting kit for the HR-02 and prepared four springs out of steel wire. This is how its done: [IMG]...
elAwesome: The special reason for me using SLI is that I want to check if it's possible. :D siliconfanatic: When designing the setup, I even had...
This one was already soldered from a very special flat ribbon cable, and it did not work out for me. I am pretty much stuck with flat cables....
Just finished testing. It is a no-no. Even worse than with the previous version. I am close to crying a bit. This is what I have done to her:...
A 140mms bridge was not long enough. I have not found a factory solution longer than that.
Update! A finally got my SLI bridge ready. It is 400mms long. Testing is expected to happen the forthcoming weekend. Here is a picture of the...
Today, I did the testing with an "off-the-shelf" 90mms long SLI bridge. SLI enabled, no artifacts at all . :rock: [IMG] Even more eager to...
Looking for SLI bridge signal speed, signal impedance, definition of the signals and pinout of the 26 pin connector information. Only:cooldude:....
Normally, it is an hour max for me, too. Except when you want something very hard. :D
Custom SLI bridge from ethernet cable postponed to next weekend. After 8 hours of soldering, using category 7 (AWG23) 900mhz cable turned out to...
Dear N!ck! This is the second time I have been advised to use good quality ethernet cable to solder my own SLI bridge. I got this advice first in...
"Did you check the output and tried connecting the monitor on the other card, or using the DisplayPort?" By default, the GTX570 on the right...
Hello again! I have already tried to wrap the SLI bridge into aluminum foil. It is actually wrapped into aluminum foil at this very moment, too....
Thanks.:)
Separate names with a comma.
