I have worked out a good way to do this but it would take a lot of time to make. 4mm thick copper bar, cut into 22mmx10mm. This is the size of...
I decided start using my watercooling again. I havent used it for over a year, but when playing games like crysis my graphics card is far too...
PWM is only good if you have a suitable powersupply to run them off. Otherwise it may be cheaper to have an adjustable SMPS - this maybe better...
Hi, I bought a ultrsonic parking sensor kit but I cant seem to get it working. I tryed adjusting both pots with no effect, and the LED...
http://www.stm32circle.com/hom/index.php...
For a high power PWM controler, cars are a good place to look.. any that have climate control should have PWM or similar (rather than switched...
If it is a plastic thread: Apply some heat using a screwdriver. Heat the tip + about an inch untill it is red hot (650-700c) and then press gently...
I noticed this 5" crt is only £5 http://www.ebuyer.com/product/105397 I am thinking how good it would be for hacking into a scope?
I doubt that... not in a car supply. Whilst I have no idea how much resistance there is from the inverter to the battery/alternator... its not...
well it helps to know what your using it for. Dont use JB weld and would recommend against solder - you seem to have overlooked is safety of the...
[img] not using a pc, just a usb hard disk enclosure (is arm based, has sd card slot, tv in/out etc...)...
Separate names with a comma.
