Still in the making :wallbash:
Support The last serious part of mod – support for turret. It joints turret with UPS. U-shaped steel profile will be a basic load- carrying...
A'm not fully understand your comment, but "respect" is nice-looking )
Tiny progress ... A small decorative element from case housing front part. Made from acrylic. [IMG] [IMG] [IMG]
Thanks for a good reference, but this only a rough replica
Visual sensor system A visual sensor system (turret from HL2): [IMG] Rear parts painted: [IMG] Rear parts assembled: [IMG]...
Video card output box HDMI and DVI video outputs, 2xUSB 2.0, Front Audio connectors, AC power 220V connector, Power and Reset buttons. A lot of...
It's alive! Finally, ready to test assembly. Doesn’t looks like a turret, but operable ) Testing area: [IMG] Front part of video card...
Turret’s gun Well, its time to make turret’s gun. Barrel – aluminum body from pocket flash, flame arrester –permanent marker cap, threading...
Paining, again A lot of fresh painted parts photo. Assortment ): [IMG] Shield, right: [IMG] [IMG] Shield, left: [IMG] [IMG]...
What is OSHA? Turret needn't to be certificated )
3D model Both turret and UPS-mount 3D model: [IMG] [IMG] [IMG] [IMG] Colors show work progress: Green – all ready Yellow – in...
UPS table mount final photo [IMG] [IMG] [IMG] [IMG] [IMG]
UPS table mount. Power ON Some progress… At first, kit for rust imitation: [IMG] And then UPS table mount. Accumulators and UPS printed...
Painting still continued...three Try a new method of rust imitation: [IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
Separate names with a comma.