Are you getting it from the german site? Are you US or UK? I REALLY like the aquatube. Our design will be very, very close to that sans the...
Thats what I would have thought. I have an alpha of it in my hand. But it is not ready for wet testing yet. I have loaned out my digital camera...
OK I know this has been on here before but I am looking at making an aluminium/acrylic air trap something like this:...
msi and epox boards I own the epox 8k3a+ with raid and built 2 machines, one with the msi kt3 ultra and one the ultra aru for raid. I liked both...
I am looking for a measured drawing of the heatsink mounting holes on amd and intel mobos I have looked on amd/intel/mobo manufacturers sites and...
blowhole pics We actually ended up doing 5 holes, six if you count the double drilling of the faceplate. Check them out - blowholes.
cutting I am actually cutting a case up as we speak. I'll post some pics in an hour or so. We are doing 3 blowholes and a front bezel hole.
holesaw It cost about $60(US) for an arbour, a 76mm, 114mm and some oil.
cutting wheels I blew through the ones that came with it then got some real cutting wheels and I still prefer the holesaw method. It is...
holesaw v dremel After using a dremel to make a few cuts and exploding several cutting wheels I finally broke down and got the holesaw/arbour...
custom fan grills I have yet to see a anywhere offering custom fan grills. I know just the setup to do these is $20-30(US) here as I have looked...
radiator in resevoir If you put the radiator from your pc system in the res all your going to end up doing is preheating the water you send...
smoothwall I have used a p120 with 48megs as a dhcp/gateway for over 90 pcs at LAN parties. It was able to almost max out our 5mb line... It...
Separate names with a comma.
