Recent Content by Skate0rDie

  1. Skate0rDie
    Post

    pika shoes?

    omg im doing this asap...!
    Post by: Skate0rDie, 29 Jan 2005 in forum: General
  2. Skate0rDie
    Post

    Electronics Pressure Switch

    as i said before im not the biggest electronic guru. How would i invert the signal... also when you say invert you mean change +v to -V
    Post by: Skate0rDie, 28 Jan 2005 in forum: Modding
  3. Skate0rDie
    Post

    Electronics Pressure Switch

    SO the QT110 active-low will put out a ground signal to the out pin whilst on the dc mod output setting. "2.2.1 DC MODE OUTPUT The output of...
    Post by: Skate0rDie, 28 Jan 2005 in forum: Modding
  4. Skate0rDie
    Post

    Electronics Pressure Switch

    I have another question. what does this IC chip output when it sences something?...
    Post by: Skate0rDie, 27 Jan 2005 in forum: Modding
  5. Skate0rDie
    Post

    Electronics Pressure Switch

    hmm oaky this will work! i dont need these buttons to be clear and i can defiantly glue a small peice of metal behind the button :clap: :rock:
    Post by: Skate0rDie, 27 Jan 2005 in forum: Modding
  6. Skate0rDie
    Post

    Electronics Pressure Switch

    iv already seen these chips, but does the pad Have to be metal? cause i want to keep the stock look of the xbox button panel. [edit] just read...
    Post by: Skate0rDie, 27 Jan 2005 in forum: Modding
  7. Skate0rDie
    Post

    Electronics Pressure Switch

    apple didnt develope the wheel they use on their ipods
    Post by: Skate0rDie, 27 Jan 2005 in forum: Modding
  8. Skate0rDie
    Thread

    Electronics Pressure Switch

    I'm modding my xbox's and i wanted to try and make a mod where the eject and power buttons are sesative like the ipod buttons. I'v alreayd...
    Thread by: Skate0rDie, 27 Jan 2005, 20 replies, in forum: Modding