Thanks a lot Jaycrow, follow me, new update soon ;)
:jawdrop: Wowwwwwww, very impressive Brother
Thank you Stallo :thumb:
Let's move to the lower side of the case because it's time to make some holes to hold the radiator
I drilled the holes and marked the centre of...
I made a test with an hold 24 pin cable and a sata one.... there is no sleeve right now but it works !
I looked closely at sata...
I drilled an hole guide for each connector
After taking off some plexy with a file.....
24Pin holes are not perfectly aligned but once...
This is how it looks like when the case will be close
Mobo fixed at the plate
I covered the sheet with a little bit of...
My main purposes for this case are:
- easy maintenance
- few cables as possible
- order, order order
Challenging but not impossible....
I made a...
Top removed and mobo on the plate
I got in radiator and psu just to see how it looks like once finished
The case from another...
Mobo-tray fits correctly !!
The holes you can see are only for testing purposes
It seems to slide in the right way....
I glued the...
Here they are....
Rails will be glued at the side of the cube in order to make a guide for the mobo-tray like this scheme:
_ _ rail...
Hi Guys, I'm back with a little up
Plate has finally arrived at home!!
I removed the protective film and now I am ready to play
Awesome "sandwich" ;)
Thanks a lot to everybody, new update soon ;)
...and the second one.
The plexi sheet is just to align the T-joint with the resrvoirs
A panoramic view of the case
Separate names with a comma.