well the upper hole was placed a little of place so I can have access to the backpart of the mosfets without having to take the motherboard out. although looking again at the pictures I thinks I will need to grind a little bit more on the middle section.. will keep updating, thanks for the support guys
It will be hard to straighten that hole up without loosing the 2 distancers closest to fan. Anyway good luck with your project.
just got myself another mobo plate from a pratorian...... will measure four times cut once to avoid the mistakes done before... will post when I get the camera back
so I'm back with the little mod that i had going on, the thing is that I managed to get another backplate, so it was a clean start for me again..... anyway this is as far as i have done this is a side view of the case. and this is some etching I'm working on.... now here is where I got stuck, it seems that the only place I can put the pump is below the hdd but the would mean a 180º turn of the tubes, so how would you guys do it???? thanks in advance
Now that looks much better . Regarding watercooling i cant help u because im a total noob at that Regards.
the use of tygon tube and tube springs, or use two 90 degree elbow fittings, however it reduces the flow alot. so a long tube, and spring will do the trick.
TapperSwe: thanks man comming from you that means alot.... nice fangrill you got going on!!! the thing is that I don't want to use 90º elbows, so the long hose and spring might be a option.....