I'm glad you were able to fix that leak without any problems! Great build! No need to worry about the temps unless they go over spec. Running...
Looking Good! Glad to see that you're working on this again!
Very Carefully ;)
I'm starving for updates :D:waah::lol::naughty:
UPDATES! UPDATES! UPDATES! :naughty:
This one's cheaper: http://www.performance-pcs.com/catalog/index.php?main_page=product_info&products_id=3387
How much of a gap is there between the back of the motherboard tray and the acrylic tank? Don't want it too close lest ye wants dripping oil on...
With the excellent work you have done on this project so far, I should hire you to make the small enclosure box for my project ;)
Another question: [IMG] Do you think the gap caused by the hinges is going to be a problem, such as dust collecting in the mineral oil or an...
Everything is looking good! Question: You drilled 3 holes into the bottom compartment...I thought you were only drilling 2: One for the inlet...
Looking good! Keep up the great work!
My thought was that the hard drive(s) will vibrate when used, which could cause some ripples in the oil if they are attached to the back plate....
Are you enclosing the oil into the middle compartment? If not, have you thought about how you are going to prevent the oil from getting into the...
Nice job with the wire management. Everything is coming along nicely! Question: How are you going to attach the drives into the top of the...
After reading an article on how to prevent the oil from ruining your hard drives, it seems to me that it's not even worth it to do it :lol:
Separate names with a comma.
