this is a small project (doesnt seem like ) ,which i hope to be over in 2 weeks or so. after countless of hours of design i got the right mod to this case ( i dnt know the name of it ) ..its finally down to the final hard work . so less talk more work ... front has led fan controler and system status diplay.. 4 X80 mm outlet fans side window the sketch up design soory in advance if the render aint good ..that is all i know
ok ..here are more pic of the case and worklog of today back panel side front top so i started laying down low adhesive tape to mark drawings area i had to change some of the original design because i didnt for see the panel remove handle hole thingy ..not much has change tho started with making insertion holes for the jigsaw..small areas i was force to switch to demel which i dnt like because the cutting disk are very hard to find.infact the one im using now its now meant for this model /maker ,i had to modify it abit. . ????? damn it started raining ..i have to continue tomorrow now this is wat i cal quicki
now its holiday season i gat free time to get this project back to track soory there is a big gup here but i finished the side window too and awaiting filiing slight problem..one of the left top corner can close because of the 2.5mm wide fan .. but i have to continue with the modding dismantling the rest of the case ... refusing to unscrew two down 2 more to go apply brutal force later i wanted red led fans but the electronic didnt have more remaining so i bought multifans then to mod them later 3 down 4 more to go