1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Modding Flopppy Power Connector pin extractor

Discussion in 'Modding' started by TwiSteD LoGic, 21 Jan 2004.

  1. TwiSteD LoGic

    TwiSteD LoGic What's a Dremel?

    Joined:
    1 Nov 2001
    Posts:
    176
    Likes Received:
    0
    Ok, I was wondering if anyone knows how to extract the power cables from the starndard power connector for a floppy drive.
     
  2. whypick1

    whypick1 The über-Pick

    Joined:
    17 Oct 2002
    Posts:
    2,014
    Likes Received:
    2
    This is a quickly-made ASCII profile of the pin:

    Code:
        \
    ---------\
    ----------
    
    That little tab sticking out of the front is sticking out of the 4 slots running parallel to the connector. All you need to do is push them down (jeweler's screwdriver set comes in handy here) and pull the wire out.
     
  3. TwiSteD LoGic

    TwiSteD LoGic What's a Dremel?

    Joined:
    1 Nov 2001
    Posts:
    176
    Likes Received:
    0
    Thank you very much sir.

    I was thinking perhaps you should post yoru ASCII on deviantart.com. It actually helped alot. =)
     

Share This Page