Thank you very much! I will try to post an small update ASAP, i did some modding to the sidepanels and PSU, not finished, but yust to give you an impression.
update As i promised an update. I'm currently working on the sidepanels, PSU and some plexiglass parts: Mounted the right side. I've glued some m3 bolts on the back, so they ar'nt visible at the sides. A little misstake was that i didn't tought about the height of the case itself, so i had to remove some parts of the frame where the bolts are mounted. New stuff has arrived, thanks for a.c. ryan - A.C. Ryan UV blue 8mm plexi - A.C. Ryan clear 5mm plexi - A.C. Ryan meshX, as 1 of the first in NL Taping it of and ready to get cut. After cutting/sanding After some olishing the are shining like premod. Don't forget these, thy had te get finished, and the holes ar'nt 100% on a straight line, but note that in worst case that would be 0,1mm difference. These speak for themselves.
Lookin' good that stuff (heb overigens al geruime tijd de MeshX in de winkel ) That MeshX is really awesome stuff!! Very nice work on the acrylic pieces Ohw... btw happy birthday
This should definately be a front page contender, willing to bet it ends up there too after its a lil more complete.
I hope so But there is so much work left, when i finished the sidepanels, rear side and radiators, i can start with the inside, electronics and watercooling. And after all ther must be that robot-like spider on the right side. Also planning to buy a tft witch should fit the theme.
update Past day's the weather was perfect, so i've been modding in the sunlight. The finished ATX cable, i hope i placed them back in the right way Finally i used the meshX panel from a.c. Ryan. I've forgotten to show where it's used for. A suprise for the next time The carton board replaced by aluminium. Offcourse it will be sprayed black, but i had to drill some holes in it before doing that. I made this today, it hasn't transparency, it's just reflection of my fingers beyond it. It was yust a experiment, so i polished it afterwards, bad idea, you can't polish the corners. Well, i just gonna use it, if it look bad, i will make a new one. I guess this would look much better than seeing the radiator and both PSU's. There will be a black sheet of alu on top of it, to hide the eges of the grill. This one is 11cm in height, the other one will be 35cm. And it's realy time expansive, it keeps me busy while i'm on holyday
Truley nice stalkers! If you get tired of that watercooling you can always exchange that for a compresosr in the top appartment Very nice mod!
Yes, enough space for it, but not enough money i guess I hope to serv a new update tomorrow... The reservoir