Can't force client to work faster with Q9400

Ha! I nailed it! I finally made it! Sorry, pardon my excitement but after all those days I made it work on all four cores. This is what I've done:

1. Downloaded FAH6.22 beta2 SMP mpich client and installed it.
2. Run install.bat in a command prompt as an administrator.
3. I replaced main executable with 6.24 smp from Stanford's website.
4. Started it as normal, which allowed me to input my username and team number.
5. Waited for it to run. Closed it, created a shortcut to the desktop.
6. Edited shortcut to add a "-smp 4" flag and run it again.

And voila!



And as you said, I was missing out on quite a lot of points. Thank you so much everybody, if it wasn't for you I'd be still folding on one core

 

Good to hear, fold on

 

Well done - it can be quite a struggle sometimes.

 

I cannot reconfigure due to IP issues.

My IP address is 10.119.252.112
I live in university halls run by Ask4.

Any guesses?
Cheers

 

Pardon? What was the question? Shouldn't this be a new thread?

You're running a on a class A address, this is a private address not a public one.
You probably need a router but my crystal ball is in the workshop at the moment.

 

LOL

 

i would recommend that you use notfred over the WinSMP your losing up to half the work time been wasted using winSMP, not sure how Synay managed to make notfred error (running it off an USB ??)

if you both need support i can do it if you wish just get Teamviewer (www.teamviewer.com) and set an time to get it all working it only takes 2-5 mins to do (if vmware player is installed as that needs an reboot)

my Sig is not working again.....