Nice setup, i just finished my PC modded Desk, i hope you guys like it http://www.youtube.com/watch?v=gLw6HvIGaWY
Hey guys, I have a CaseLabs S5, and as some of you know, its 100% aluminum. I need make some screw holes in my S5 to attack a res to the side. My question is how would i go about doing this? Im following http://www.youtube.com/watch?v=tng-40zrUY0 [1] and can i just go from the initial screwing of the small thing from the machine screwdriver to just slowly screwing the final screw i want in? Or does it not work like that Or is there any other method? Thanks!
not sure what to do with grill/venting for GPU area Top and bottom panels either going to be redone via full 3d print or small section created. Gaps at the side with Metal mesh inside was either thinking hole cut roungly size of 280 aio with metal mesh or 280 rad grill panel in metal with magnetic silverstone filters on the inside ...