The one shown is Copper red. Yup no dyes used just a special mix of our pre-mixed liquid + suspension + pearleasnt. The pearleasnt used is coated to help keep it separated.
What sort of flow rate do you need for the particles to be visible? Although I'm assuming it's low I just wondered how low. How well does it cope with micropins on a block?
That would look ace in my ram block loop, as i dont need much flow for the ram. Infact i tend to use on 1 on d5 or even off is ok in cooler weather or non oc modes. would like to see your vid when you can. Is that white fluid available whilst your on?
That's interesting. At low loads my pump's doing a calculated 200lph with PWM at 20% (with no restriction), probably half that with the blocks in the loop so I reckon I could see the effect. I'll be interested if this becomes available.
Im still working on getting the mix correct as im trying to avoid fall out with in respected flow rates. The pearl does separate when left alone how ever its picked up the instant you turn on the pump. Its just trying to get the fine balance between looks and this problem. It will take a little time to get right but ill get these in the end.
They all look very cool Mayhem Nice to read they are handling abuse as well Have you made any reservoirs with lots of chambers/paths inside them? If not, then you must!!!111 I think they would be uber epic with any of these fluid mixes
has any testing been done yet, and when can we expect to see these on sale? I am interested in buying the galaxy one for my white and purple tj build Sent from my GT-I9100 using Tapatalk