Scratch Build – In Progress NFusion - IgnitiOn Project 19-FEB-2013

Nicely thought out and designed. I can't imagine the design work that went in to it. I look forward to the rest of the build. Nicely done!

 

whooaaa, i thoght they were 20mm holes.
Thats crazy dude !

 

Thank you both.
Yup, countless hours went into design, but at the end it will be worth it.

yea, 5x 180mm fans all with Magicool radiators for BEASTy cooling.

 

Short Update - Radeon HD 7950 Waterblock installation


EK Full Cover Water Block EK-FC7950 Acetal+EN
with EK-FC7950 Backplate







Taking apart 7950 and start cleaning TIM. I used Akasa TIM clean.




Cleaned GPU and applied thermal pads.




Applied fresh TIM. I used Arctic Cooling MX-2.




End result

 

Thats a nice looking card you've got there

 

thats looking awsome why not CSQ block?

 

Because CSQ is ugly?

 

DAMN!! Very nice indeed!! Would love to do a scratch build like this one day, but alas, access to engineering equipment and skill to do this is what I lack.

Heck, if I were to attempt something like this, I'd probably end up missing a limb afterwards.

Subbed!!

 

Oldschool EK blocks = YES!!!

Also; new case design = YES!!!

 

Yes, i think these blocks will look better in this build.

And the CPU block is also oldschool

Thanks.

Don't worry you would be fine

 

Quick update.


I finally have all of components, so this project will go fast

I installed components and finished tubing.







Next up is leak testing, hopefully everything will go well

 

QFT!

NFusion, you sir are an extremely talented individual, looks AWESOME, great attention to detail and stunning execution.

Looking at it again, and again, and again the tubes going through the grill just look somewhat .... out of place i guess, kinda like an after thought, you could go with some bulkhead passthrough fittings just out side the bottom grill, use 45 degrees and you would still retain those luverly curves on the tube
Hope i didnt offend, still looks great either way

 

Hi Father-Time, thanks for the kind words, it means a alot to me.

Hmm, i also think bulkhead solution would be better, but i would have to order these fittings, which means waiting for atleast one and a half weeks to finish this build.

Normally this isn't a problem, but i have a client build that needs my time

No offense taken thank you for healthy criticism.

 

Hi everyone.

The Ignition project is on the final stretch. The leak testing went well, so i also did all the wiring, lighting
and finished project IgnitiOn.














Thank you everyone for kind words and encouragement.

Next project is a client build, so stay tuned

 

Well Done Mate!!

Looks fantastic, lighting looks really good without being too much, second to last pic, res looks stunning.

 

Looks really nice!

 

wow really wonderful job you did on thise plastic cuttings and putting the case together, if it was me i rather coose to do something otherwise..

really great job high rated from here... do you make those laser cuttings for others ?

 

Hi Lehani.

Yes, i also do client builds and i'm seriously thinking about making one "production" case

 

Loving it so far

 

looks stunning!