Hi I was wondering what everyone else was running on their system. I'm running XP2000+ with Volcano 9 with Ducting Mod and I get 52 C on regular usage.
i have been playing with a stock 1800+ system. Tbred core, Coolermaster HAC-V81. This ting runs at about 20 C idle, and 32 C load. The lowest i have had it at is 10 C at idle. Very nice.
Those temps just dont seem right bob. Wha did you use to measure them ? My CPU idles around 40°C going upto 45°C on load System temp is around 26-28°C All measured with MBM so +-10°C
XP 1800 t/bred B @ 2600, with sunon fan @ 7v, 41°C load, @ 12v, 38°C load. currently using ystech silent, 45°C load case temps ebtween 27 and 30
MaSHim0t0 - Same setup as you (TT Volcano 9 and XP2000) I'm getting 42-44c on average useage and 48c+ on full load. But I'm looking to replace the volcano 9 soon as it's waay too loud,
Barton 2500+ @ 2150mhz (205*10.5) with SLK800 and a smartfanII at about 7vish currently 38-42c idle and 45-48c load. I say currently because the ambient temps change dramatically where my comp is. Last winter with a stock tbird 1.1 and a stock HSF i was getting load temps of 16-20c but ambient temps were often 5-10c.
35 idle, 40 load, but my computer is currently in a desk (read: thick wood insulation) so they're a lot higher than they should be. That's probably MBM being wrong anyway...
their a bit to high...what are youre case temps like?? and most importantly ventilation?? i ussually get about 27-36idle (depending on the season) and have had a max of 42 on my tbred sofar....
xp2000+ 37Degrees (right now) System 32degrees (right now) Coolermaster X-dream @ 3000 RPM 2 front intake fans - 80mm top exhaust - 80mm rear exhaust - 80mm 2 fans on psu Soon to be buying Swiftech MCX-462+ and maybe 2500 barton
XP1700 @ 2375MHz 35 idle, low 40s under heavy load. Swiftech MCX-462 and a big delta. Measured with MBM so give or take a bit.
okay, update. I was reading the temp from the bios. I just used tose parts to upgrade my current system today, and it now sits at 30 C idle. Dunno how i got 15 C, just wish i could get it again.
Do you live in Alaska mighty bob? You'd have to be a room of about 5C to get those temps. Edit: I see you got in your post while I was typing Still...your room would have to be pretty damn cold for those temps. I suspect dodgy motherboard readings.
webtemp owns j00! Barton 2500+ @ ~2.31ghz 1.775v full load 24/7, no motherboard heatsinking as yet, so temps are still a tad high
I got the ANTEC 1040BII with A7V266-C Two fans in front, two in rear. My Volcano 9 is running at 3/4 speed of 1300-4800 And as i said, I'm getting now 50c on my cpu (XP 2000+) 26c on MB 28c on HD That's just regular IDLE. When playing games my CPU Temp jumpts to 53c I cleaned up my case (Wires in good position, no dust, etc..) Are my temps normal? They seem 10c higher than you guys BTW I never put in thermal paste.... would that help?
haha whoops, i never knew what the paste did, though it was like glue to help hold the cooler well put in the paste, thankfully i didn't throw it away. Anyways at 4800 RPM my idle is going 47c ugh... anyways to lower it more? I'm surpised I'm not getting 43. I also have the ducting mod... and it aint helping.
Mine runs about 38 to 42 between idle and load. It's an XP 2500 OC'd to 2.4ghz on water. It's a Swiftie MCW5000 block and the CPU's at 1.85v, if anyone's wondering.