Which "posts" are you referring to?
I think orange sleeving is pretty common, you can find it in most places like Frozencpu.com or if I'm correct Vantec still makes them.
For a fellow Canadian check out these guys:
http://www.eurocom.ca/ (Canadian Company)
or you can also check out these guys:...
OK so Phase 1 of Carbon Cobra is now complete!
I basically have it being used as a workable computer now!!
All the wiring was completed and...
Interesting.. try maybe getting a better drill and preferably not a cordless as they usually don't have enough torque.
I say call it Project Derelict!
The built-in Modem is probably made by Sierra Wireless and it's probably based on the SB300 chipset.
If I remember it uses CDPD. I could be wrong...
I always prefer getting paint from the auto store... they usually carry the better automotive quality spray paint.
Yeah as long as you're careful with the glue gun and not get it in a place where it's visible.. take it from me.. it's almost impossible to get...
Yeah take your time... painting can take days to complete... and the key is thin thin coats.
Why not use some standard 2 pin lead connectors... like the kind you use to connect LED's to your motherboard?
Just sounds too much like revolting to me... my bad.
It's no question it's a nice product I just wouldn't have picked that name.
I used glue for my mod.
I am so doing this...
HAHA Dude.. lots a good planning and not settling for anything but perfection.. Good on ya!
What I would do is cut a panel exactly the size or slightly smaller then a panel that is about an inch larger. Mount larger panel on the inside...
HAHA No worries dude... I did this as well myself. Just pickup a good Mandrel and get the appropriate holesaw in Bi-metal and that should fix your...
OK I gotta few things that might help you out here.
I would suggest filing down the sharp ends there.. the hole still appears to be visible even...
Separate names with a comma.