In the next step I expanded the tray. I hope I can use the complete back cover from the case.
Today i start my Worklog of my new project.
It`s a Contest Casemod at Hardwareluxx
But first i thank:
Thank you very much.
N:thumb:ice that you enjoy it all .
Thus ended after the contest.
After contest end, I have a monitor and a Bluetooth speakers rebuilt.
ModdingMasters 2016: 1st...
Next, I painted the keypad and missed a great distressed look.
In the front, I have made a slot behind the front panel....
Only the installation of the SSD and PSU mount.
Next, the keys were stuck on the panel.
Then again everything...
Time for an update:
It continued with the support of Radi and pump.
In addition I have first cut and folded sheet metal.
Nice Work Ali.
Very awsome handmade skills, nice Tubing.
Time for update:
The copper plate I satin honed, split the cooler and cut thread.
Next, the fitting followed on board. Fits...
In the reservoir, I have welded a strut.
clean This wears out the battery box and walk through the narrow remaining opening later the cables...
Today a packet has arrived again.
Tanks to Enermax for the support at this project.
Here's the overview.
A BT speaker...
It continued with the expansion tank
First I cut pipes for the other two sides.
he tubes I then halved.
Today we went to the reservoir.
The will be the supporting part in the case.
The container is made of 25mm aluminum tube....
So on it goes to the front.
First I printed the front glued to a sheet and then oriented.
From the rotary switch I need only...
Working @Radio Beacon
Ya Ali I have to agree with you.
How good a modder is can be recognized by his handiwork.
The day I started with the front...
the mod will be my worstation at the Workshop.
I welded it with Tig / Wig
Livestream in 15 minutes
I have drawn even further.
First all components radiator reservoir and pump
Radiator will be a 2x 80
The reserve tank...
So packets have come
First the case.
Then the antenna and connector has arrived yet.
Same time to unpack...
Separate names with a comma.