Thanks a lot Jaycrow, follow me, new update soon ;)
:jawdrop: Wowwwwwww, very impressive Brother
Thank you Stallo :thumb:
Let's move to the lower side of the case because it's time to make some holes to hold the radiator
I drilled the holes and marked the centre of...
I made a test with an hold 24 pin cable and a sata one.... there is no sleeve right now but it works !
I looked closely at sata...
I drilled an hole guide for each connector
After taking off some plexy with a file.....
24Pin holes are not perfectly aligned but once...
This is how it looks like when the case will be close
Mobo fixed at the plate
I covered the sheet with a little bit of...
My main purposes for this case are:
- easy maintenance
- few cables as possible
- order, order order
Challenging but not impossible....
I made a...
Top removed and mobo on the plate
I got in radiator and psu just to see how it looks like once finished
The case from another...
Mobo-tray fits correctly !!
The holes you can see are only for testing purposes
It seems to slide in the right way....
I glued the...
Here they are....
Rails will be glued at the side of the cube in order to make a guide for the mobo-tray like this scheme:
_ _ rail...
Hi Guys, I'm back with a little up
Plate has finally arrived at home!!
I removed the protective film and now I am ready to play
Awesome "sandwich" ;)
Thanks a lot to everybody, new update soon ;)
...and the second one.
The plexi sheet is just to align the T-joint with the resrvoirs
A panoramic view of the case
These are all the pieces ready to be put togheter
I checked the holes with a plexi tube (diameter 10mm)and it fits perfectly!!
Now It's time to build reservoirs and put in place the "T" joint made before.
The fist thing to do are the the lower and upper caps of the...
Leds' fitting test
I made four tracks with a diamond disk in order to sthealt pins' leds once soldered
Here they are...soldered...
After some work....ta-daaaaa here it is the cube
I want to light it up, so some sanding is necessary.
Four marks for four leds...
Now it's time to widen the holes with a 10mm dril bit
Drill bit---> alligned!!
Let' start drilling
have a look at the...
Separate names with a comma.