Search Results

Search Again
  1. fleng
    Post

    Scratch Build – In Progress Project: Filmiarvuti (update: July 4th - finished!)

    looks good mate so far! Always love scratch build HTPC :)
    Post by: fleng, 5 May 2009 in forum: Project Logs
  2. fleng
    Post

    Scratch Build – In Progress ****** PHINIX CUBE ******* - the one and only:)

    Hey Phinix, when you cut out those "in shapes" out of your 5mm Acrylic with your Dremel, what drill bit do you use ?? I wanna cut something...
    Post by: fleng, 12 Apr 2009 in forum: Project Logs
  3. fleng
    Post

    Planning Thougths about my new projekt: Broken dreams

    Pretty nice and simple design and very effective. I am also building something like that for my 2nd Rig.
    Post by: fleng, 12 Apr 2009 in forum: Modding
  4. fleng
    Post

    Modding Drill bit for cutting in shapes of Acrylic??

    Nice!, I will find a 2.5mm anbd 3mm Drywall bit to fit into the Dremel's collet. Thanks again to both posters :)
    Post by: fleng, 11 Apr 2009 in forum: Modding
  5. fleng
    Post

    Modding Drill bit for cutting in shapes of Acrylic??

    Yeah, Ive used the plain old wood Drill bit, does the work, but kinda slow and melts the acrylic. Just wanna get some good advice before I get...
    Post by: fleng, 11 Apr 2009 in forum: Modding
  6. fleng
    Thread

    Modding Drill bit for cutting in shapes of Acrylic??

    Hi guys, I was reading some project logs and found something I needed to read about. It was about using Fine Drill Bits on the Dremel to cut...
    Thread by: fleng, 11 Apr 2009, 4 replies, in forum: Modding
Showing results 1 to 6 of 6
Search Again