Well as long as you're aiming high, try to get a hold of a copy of The Art of Electronics. WONDERFUL book. Not so much for the beginner, but as...
I'd really go for the 120mm just from a noise standpoint. Same air at less RPMs so quieter operation. Can always crank the 120mm back on up if...
Nice look. Few suggestions for ya to chew on :) If really going for an htpc, i'd up the ante on the memory, ESPECIALLY if this is going to be...
Yes discharging a monitor before working on it is proper procedure and is safe if you know what you are doing. However, I gathered he wanted to...
You could remove the casing and move the guts to a seperate area, but you will still have the tube and gun portion extruding back. Separating out...
As far as the switch is concerned, I would image you could get a momentary DPDT switch, hook up the leads from the power switch to one side and...
From the looks of it on the ammo pc, you can get similar 4 pin DIN connectors from radioshack. They are CB mic connectors. Bout a buck 50 a pop...
Depends on what you're connecting to/through and how handy you are with a soldering iron. You could get some kynar wire from radio shack (30AWG)...
Yeah, I've always wanted to do some fiberglass on stuff to make custom enclosures, but never an entire case. Good luck with that! :dremel:...
Well not really, especially if you buy a hardware decoder (hauppage 250/350/roslyn cards etc) You can get just the 250 card for $130 from...
you can browse teh articles, galleries and forums at www.htpcnews.com to get a feel for what others have done.
here? no. Well you can always import em, but that will cost you an arm, a leg, and two kidneys. Word is they got em over in Oz, and seeing as...
Yep, buy a hole saw for your drill, not the spade bit kind. I don't even think they come that large for spade bits, least for john q public...
Cutting the hole in the top would get you nothing but the butt side of a board to look at :D Many, many car stereo install systems expose the...
Why not use one of those removable hard drive cages? Give is some place to slide into, a box that's already a ready made drawer for the tools....
Well, what you're cooling in an amp usually is several MOSFETs attached to the sides of the heatsinking amp body. Not sure about what all is...
Actually, a little more digging and I found a workaround using the serial port. While not ideal, (added weight) it may work. Course suggestions...
Thanks for the input Blue Raven, no offense taken :) , you hit it on the nose. I have used charmed tech's Charmit wearable pc for similar tasks...
I am attempting to clone the video signal from the ipaq. Click the link in the initial thread for the basis of what i'm trying to do (pic),...
Trying to figure out a way to get a headsup display to compliment the ipaq screen without using the compact flash slot or wireless. (slot already...
Separate names with a comma.
