The thing that jumps out at me in this conversation is that no one has mentioned what exactly they are modding. If I buy a lighted fan or build...
Thanks guys, 150 ohms worked like a charm! I'm about to run out of the house again, so I'll be going over the math later to make sure I can do...
Because I don't need to limit the voltage (4 in series should be 12v), would I use the smallest resistor I can find? Like a 10 ohm 1/4 or 1/2 watt...
I got a bunch of red LED's from FrozenCPU and have been having problems with them. The information I got from FrozenCPU was that these LED's use a...
I don't have a spare. :( But a would a dead IC have all the correct voltages on every pin but the output pin? And also, the output pin constantly...
Ok, I've got a pcb board with two QT110 IC's on it. Wired up the first one, it's working great. Wired up the second one, and it won't work. Here's...
The pen I got lists the resistance at .2 ohms per mil, which I believe is .001 inches. That would add tons of resistance in a 4" trace, so I'm...
On my power button PCB I got a solder ringed PCB and ran wires between each connection, because I was sure it would work. :) I'll pick up and...
After soldering together my first PCB board (A QT110 power switch, which was a success), I was curious about something. I used wire for all the...
Heh, this will be my first dive into anything more complex than adding a resistor, can you tell? :D Got it now. Thanks for the help. Astaroth
Not really sure. :P Depends on the sensitivity, hopefully I won't be pawing at my case constantly. Figured for $1.80 I'd try it out. :D One...
Thanks for the help, g0th and whypick, I ordered the parts for the switches a few hours ago, the rest of the parts should come tomorrow, so I'll...
While I'm at it, I'm planning to use two of these switches, one for power and one for reset, there wouldn't be a problem with that, would there?...
Then I assume I'd pull the 5vSB for the QT110 from the PSU directly? (Perhaps off the ATX connector). Also, is this the QT110, not the QT110H?...
Heh, please ignore my misplaced decimal place. :D I might order it from Digikey with the QT11's, I was just using radioshack site because I'm...
First of all, I'm borrwing this schematic from Coorz, sicne I'm using that as a reference. If there's a problem, please let me know, and I'll take...
That's what I'm thinking, taking some sandpaper to the back of the plexim,ditching the paper. I'll have to see if four LEDs will cover the whole...
I apoligize for the lack of pictures showing what I'm trying to do, I have to ask my girlfriend what she did with the camera. :( I've got a...
Separate names with a comma.
