Project put on hold for short time.
I am in the process of changing jobs, and I will now be working out of the house. :rock: :rock: :rock:...
Can't wait to see your execution of this design.
I am planning on using plywood for the "skin" and re-enforcing the joints with 1x1.
I was planning on making it out of plywood.
I have a new design in mind for my next case. It is L shaped. I have decided to do this so that I can fit my case in the corner of my desk, and...
Graphics is TNT2 64 PCI card, saving for an upgrade.
Paint was the 98cent Walmart brand.
No so far.
The mesh window acts as my exaust vent. I have all my case fans blowing air into the case and exausting out the window. You...
Painted inside flat black. Painted outside high gloss black. I used the 98cent Walmart brand spray paint.
Sure will. It may take a little time, but I will post one soon.
I have two red led fans one in back and one infront behind the mesh. The front one glows really nice but side window is a little dark.
That is what it is alright. Actually it is and extension cable for stereo headphones. I cut the ends off, zip tied them to the cables and...
I'am planning on adding to it, but at this point my ideas have run a little dry.
I tried a fan controller but it did not provide me with much...
Thanks. I got the case from Tigerdirect, $29.99.
[IMG] [IMG] [IMG] [IMG] [IMG]
I took the following case.....
Added some black paint and the mesh from a trashcan and got this.....
I just recently completed my Stealth Themed case. Here is a picture of it.
Separate names with a comma.