Well done man. MOTY choices this year are going to be EPIC and very hard to decide :(
Agreed. I can't wait to see the final outcome of that build. This is more of the more unusual design's I've seen so far on bit tech.
Aye. Images are nuked/screwed up. PMing OP to see if he can fix it.
Dude.... your on the top on /r/all on reddit:
Holy ****! Mmm..... copper pipes.....
On a more serious note, how much additional weight is the copper pipes say over using something like LRT?
Not necessarily. If you have a lot of fans you can dial down the rpm with out increasing temps. I haven't been able to go through all the logs,...
I'd say put some/most of your games,etc on it instead of MP3s. 80GB should be plenty to hold a bunch of modern games + mods.
Investing in any a...
You sir have more determination and patience than most people.
\o/ Sleeving is done!!!!!
Looks good btw.
Also, how accurate is that PSU tester?
Nice. As for the bleeding, have you considered painting it with something like rubberizing spray? 1-2 coats of rubberizing paint will completely...
Looks like a good start. My only concern is is the epoxy you are using strong enough?
Quick question, where do you guys buy the acrylic,etc from?
Actually, it's not an over blown issue. Some people have run mixed metal loops pretty fine for months with out many issues. However, there have...
Quick question, is the back panel image 1:1 scale? Actually, are all of these 1:1?
Wow dude, I've used the same sink and I don't really notice the sound. Do you have the PC right next to you or is it on the floor away from you?...
Why is that pic in B&W?
Anyways, the HDD cage looks nice.
Good point. You could probably find full aluminum car rads,etc.
You are going with a Al + Copper loop? I assume you will be using 50/50 mix then?
Personally, I think you should have gone with a full Al loop....
You know, now I may start doing that....
Don't the lights annoy you when working?
Separate names with a comma.