couldnt agree much more with the article i played it it was ok for 60 mins then i got bored and went and played ut2004. The reason i got bored...
couldnt agree more really ive been using the same xp1800 with a gf3 and 512 of ram for over 2 and a half years yes YEARS ive only just upgraded...
interesting thought there . . . shame the people in power arent geeks they might see it the same way but i doubt it will happen with politicians...
having read some more of the arguments here i think a link to Hackthissite.org is in order as although its another one of these sites that teach...
its not specific to the hardware of software tho . . . u just need to pay for a licence but as linux is free they wouldnt be able to distribute it etc
yeah this has been floating around for a while still with you. some good points you forgot all the people that just dont care about what the...
i doubt there will ever be a fast ps2 emu as the ps2 cpu is 128 bit (according to lecturer at uni) so i think emulating that on a 32 or 64 bit...
er houses if we get em up to around 12 ppl in a small living room gets squished but good fun The local scout hut for anything up to 20 odd...
cheers . . . i dont know how i missed that :confused: /me feels silly
im not sure thats quite right as if the l + r channels are connected with no ground u still get sound out but its the diff between the l and r...
not sure if instruction set is hte right word but meh not really sure if this is a software question or a electronics as its for a micro...
cheers again dont know why im making this fan controller really tho as i only have 3 low noise fans in my pc :-/ oh well ill give it to someone...
i usually check with the gnd on the chips too also check that the ICs dont need -ve voltages cos applying the + without the - will almost deff fry it
finding ground on most pcbs is easy just do continuity test between one of the big areas of copper (scratch off the lamminate) and the pins to...
errrrr can u give me an idea of what to change the values of the resistors to to work with a 100k digital pot as i havent really used transistors...
heh was about to post a question about emitter followers but thought id google it 1st. . . google turned up cpemmas page /me feels silly...
which voltage pin? and not too hard if u have a way of getting the data into the microcontroller. an ADC would be easy to use to get the data in...
ive had the code ready to test for a while and i finally got off my back side and did it today (instead of revision) [IMG] the program is...
i think this is how the winbond chiup does it. the chip used in the pwm article on the bit site uses a freq of 30 hz. i dont understand a lot...
you could put a cap in series between the motherboard and fan sense line. IIRC this allows ac signals to pass and DC gets blocked so the pulses...
Separate names with a comma.