Yeah I agree covers on was much better but if there's no way round it. I assume it's not possible to watercool the SB, cutting holes in the covers...
Jesus H Christ.
Working again now :)
Haven't read all 48 pages so sorry if it's been mentioned, but the ATI x800 card isn't working (dead link).
cheers :) i was afraid they might not work pin for pin having looked at the pinouts but ive done what was suggested above on an old keyboard to...
Is it possible to take a PS/2 keyboard and wire a USB plug on the end in place of the PS/2 plug? If so can anyone give me any ideas on which wires...
Hi guys thatnks for the replies gman - yeah i got what you mean, i meant to say on its own line not on its own molex, so yeah its got a...
the graphics card is on its own molex, and my PSU is pretty good as far as i know, voltages are rock solid and ive never had any issues with it...
I'm having a very annoying problem, every now and then my monitor (NEC MultiSync LCD) will go completely blank and will remain that way until i...
Definitely something not right there still, im using a stock intel HSF on a 3ghz P4 at 3.4 and my load temps are about 45c, maybe its the...
Ive got an antec trueblue 480w which runs 9800 Pro, 5 HDDs DVDr Few fans etc with no probs, very stable voltages too.
i had exactly the same problem, and it turns out i'd accidently put the IDE cable in upside down (the pin peirced a hole in the blank section so...
have a look at the chieftek bx range, i just got a BX-02 a few weeks ago and its very nice (no good if you go to lans though, it weighs a ton)
nice plan!
did you replace the PSU with a decent one or was the original one good? If not and youve checked and double checked all your connections id try a...
yes :thumb: should be fine
^^ agreed, i just installed a 9800 a couple of days ago with the same problem, as soon as i installed my mobo drivers 8x was enabled (and...
well im no expert but thinking back to my school science lessons, copper is a better conductor of heat than aluminium so id imagine it'd be better...
happy to report that all is running great with the new PSU, and im getting a much less scary 3.26v on the 3.3v line :D
yeah ill definitely keep it off till the antec arrives, i just hope its the psu. I suppose if the graphics card is at fault i can rma it.
Separate names with a comma.